Home Office Seattle WA
Call (800) 261-7282
Call (800) 261-7282
NOTICE: Proceed with the guidelines during the Manual that included the ho tub or health spa. Do not turn on energy to your health spa until instructed to do so according to the guidelines in your manual.
1) Many providers highly recommend that only a licensed and fused electrician do the electrical installations. Incorrect electric relationships may spoil the apparatus, cause injuries, cause a fire, and void their spa guarantee.
2) it will be the responsibility on the health spa manager to make sure that a professional electrician runs the electric installation. This installations must certanly be in accordance with the nationwide power Code; local and state electrical requirements; as well as the manufacturera€™s information.
3) Many spa and health spa machines has been designed to operate on 240 volts, 60 Hz alternating-current electric wiring.
4) The spa must certanly be linked to a passionate department routine.
5) The electric source for this health spa must feature a properly ranked change or routine breaker to start all ungrounded supply conductors to follow area 422-20 of the state electricity signal (NEC). A disconnect switch must certanly be set where apparent, for around 5 ft from the salon rather than to exceed 50 base from day spa. This necessity could be full of the GFCI circuit breaker and sub-panel.
6) The electric routine on the day spa must integrate a course a kind soil error Circuit Interrupter (GFCI) as needed because of the NEC when it comes to electrical-wiring.
7) All provide wires should be copper and rated at least 194A°F (90A°C).
8) Input Electricity Wiring and Circuit Breaker Variety:
Important Info With Regards To Power Construction!
Setting Picking Jumpers:
As found into the dining tables below, some makes and type hot bathtub and spas incorporate a jumper when you look at the equipment controls box that configures the form of process. We have found an average scenario when a hot bathtub or spa makes use of this feature – During The HC Mode the heater will work with two pumps operative. Within the LC Mode the heater transforms off if either push is during fast or if the blower is fired up.
Best a licensed electrician should
The apparatus kind column doesn’t come with the blood circulation pump
Standard process and guidelines to hook-up their salon:
1) Remove the screws holding the gear access section on top associated with the salon cupboard and set the board away.
2) Loosen the two screws toward the base side regarding the blue, equipment control enclosure.
3) need A?a€? flexible, non-metallic conduit for a day spa needing #10 AWG or #8 AWG wire or 1a€? versatile non-metallic conduit for a day spa needing # 6 AWG cable. Work the conduit from energy source to the health spa, through the hole for the left or right top corner and in to the machines controls field.
4) After taking all wires through the conduit and into the devices regulation box, link them to appropriate terminals as showed because of the wiring drawing regarding the top regarding the products controls twoo app package.
5) Configure the jumpers on correct position as indicated from the wires diagram from the lid with the products control package. Ensure that the cable are effectively tightened.
6) Close the lid in the machines controls box and protected with screws. 7) electric hook-up has become complete. Do not replace the gear door however.
Tony asks: i have heard more often than once, that one must install a GFI container, close to the health spa, it should go to the electric panel box. What is the undertake this, since I have need to pump engines? Tony
Dave’s address: Yes Tony, that is true. The NEC signal states that the disconnect should be within look associated with the hot tub or salon. Also, every machines definitely linked to the hot spa or salon ought to be secure by GFI, since your inspector should be certain to explain.
Installing Hot Tub wires therefore the detachment board: outlined instance of Installing the Electrical Wiring for a Hot Tub and GFCI Circuit.
Electric Circuit Wiring for a hot spa routine: The electric routine try a passionate GFCI protected circuit. Most hot bathtub expected a 4-wire routine that has another natural and individual soil combined with the 2-conductors which provide the 240 volt circuit.
Just how to apply spa power routine wires: could i manage a normal 6AWG 3 conductor cable plus surface through a single inches conduit or would I need to run backyard 6AWG cable?
Whenever setting up the power Circuit wires for a Hot Tub it is vital to choose just the right cable tv in order to be sure it is precisely grounded with GFCI protection.
What is the right way to Ground swimming pools, Spas and Hot Tubs? Im installing a packaged above-ground health spa. I’ve a 50amp breaker during my panel feeding a GFI detachment section near the spa.
Tips Wire a hot spa Circuit: power requirements and Details for health spa and Hot Tub wires. Essentials to suit your installment, including the required GFCI ground mistake safety and circuit cable proportions.
Exactly why is my brand-new hot spa no longer working correct? Exactly why a hot spa ends doing work therefore the Breaker Does Not Trip.